In such cases it is necessary to assume that the influence of the different holes is not the same in all directions, which assumption of course is absurd. But as ore deposits cannot always be drilled into at regular intervals and because of the human factor, if many holes are drilled, triangular prisms of all degrees of angularity are produced. The standard method is correct when the drill holes are so laid out that the triangular prisms are equilateral in cross-section. Some engineers, therefore, use a discount factor, but as this factor is either arbitrarily selected or is obtained by obscure methods, the results are no better than guesswork. As the latter part of this method is subject to many mathematical errors, it should not be depended on. The assay value is found by dividing the sum of the products of the depth of ore in each hole and the corresponding assay value by the sum of the depths of the ore in the three holes. ![]() The standard method of making these estimates is to find the cubic contents of triangular prisms, in the apexes of which the drill holes are placed, by multiplying the surface area by the average depth of the ore in the three drill holes and then multiplying the cubic contents by the specific gravity of the ore or rock to find the tonnage. ![]() In a large number of cases, the results of exploitation fall far short of the estimated value of the orebody. Though the results thus obtained may not represent the true average value of the deposit, it is on these results that estimates of practically all large orebodies are made. The usual method of sampling mineral deposits is to drill holes and assay the sludge or core.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |